VTech Mix & Match-a-Saurus User Manual

4
4
4
BATTERY INSTALLATION
NOTE: For best performance, remove all factory-installed batteries
from the Mix & Match-a-Saurus
TM
and use new, alkaline batteries.
1. Make sure the unit is turned OFF.
2. Locate the battery cover at the bottom of
the unit and open it with a screwdriver.
3. Install 4 new AA size batteries following the
diagram inside the battery box. (The use
of new alkaline batteries is recommended
for maximum performance.)
4. Replace the battery cover and tighten the
screw to secure.
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Donotdisposeofbatteriesinre.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.

VTech Mix & Match-a-Saurus Specifications

General

Brand	VTech
Model	Mix & Match-a-Saurus
Category	Toy
Language	English