2
GETTING STARTED
POWER SOURCE
The Nitro Notebook™ operates on 3 “AA” size batteries
(UM-3/LR6) or a VTech
®
9V adaptor (sold separately).
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom of the unit and
open it.
3. Insert 3 new “AA” batteries (UM-3/LR6) as illustrated.
RECHARGEABLE BATTERIES ARE NOT RECOMMENDED.
4. Close the battery cover.
NOTE: For best performance, remove all factory-installed batteries and use new,
alkaline batteries.
Important: When replacing the 3 “AA” size batteries, make sure the backup batteries
are in the unit. Otherwise you will lose any information stored in the unit.
BACKUP BATTERY INSTALLATION
Your Nitro Notebook™ comes with a backup battery already
installed. To avoid damage to the unit from leaky batteries,
replace the backup battery at least once a year.
TO REPLACE THE BACKUP BATTERY
1. Make sure the unit is OFF.
2. Using a small cross-head screwdriver, loosen the battery cover.
3. Insert 1 CR2032 size battery as illustrated.
4. Close the battery cover and tighten the screws to secure it.
STANDARD FOR BATTERY TOYS
•Do not try to recharge non-rechargeable batteries;
•Rechargeable batteries are to be removed from the toy before being charged;
•Rechargeable batteries are only to be charged under adult supervision;
•Do not mix different types of batteries; Do not mix new and used batteries;
•Only use batteries of the recommended or equivalent type;
•Always insert batteries properly matching the plus (+) and minus (-) signs;
•Batteries that have run out of energy must be removed from the toy;
•Do not short-circuit the supply terminals;
•Do not use more batteries than recommended;
•Do not mix alkaline, standard(carbon-zinc) or rechargeable (nickel-cadmium)
batteries;
GETTING STARTED
65000 manual-back up 5/24/05, 13:202
To Next Page
Loading...
