4
GETTING STARTED
Battery Removal and Installation
Note: For best performance, remove all factory-installed batteries from the Peppa
Pig Learn & Go Alphabet Car and use new, alkaline batteries.
1. Make sure the unit is turned Off.
2. Find the battery cover on the back of the
unit and use a screwdriver to loosen the
screw and open the battery cover.
3. Remove old batteries by pulling up on one
end of each battery.
4. Install 2 new AA size batteries following the
diagram inside the battery compartment.
5. Replace the battery cover and tighten the
screw to secure.
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-zinc) or
rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity (+ and - ).
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging.
• Rechargeable batteries are only to be charged under adult supervision.
To Next Page
Loading...
Need help?
General