5
Getting started
Parent unit installation
Install the parent unit as shown below.
Make sure that the power outlet is not controlled by a wall switch. Bundle the
power adapter cord neatly with a twist tie.
When the battery pack is installed, the light turns on while charging.
Use only the power adapters supplied with this product. To order a
replacement, visit our website at www.babymonitors.vtech.com or call
1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call
1 (800) 267-7377.
The power adapters are intended to be correctly oriented in a vertical or oor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
Make sure the units and the power adapter cords are out of reach of children.
•
•
•
Parent unit
Power outlet not
controlled by a
wall switch
Power adapter
The light remains
on when the battery
is charging.
To Next Page
Loading...
