VTech Sing It Out - Bluetooth Connection and Power Management; Connecting to External Devices; Automatic Shut-Off and Low Battery

10
Connection
1. Hold the Bluetooth
®
Button down for several seconds until the
Bluetooth
®
Button lights up and flashes.
2. Enter the Bluetooth
®
interface of your device and begin searching
for Bluetooth
®
devices.
3. Select “VTech 5510 Microphone” when you see it displayed on
your device.
4. The microphone will provide audio for the PIN code, which you
will then enter on your device.
5. When the Bluetooth
®
connection is successful, you will hear
a sound effect and the phrase “Bluetooth
®
connected.” The
Bluetooth
®
Button light will remain on.
6. To exit Bluetooth
®
mode, hold the Bluetooth
®
Button until you
hear the phrase “Bluetooth
®
disconnected.”
7. The next time you initiate the Bluetooth
®
connection, the
microphone will automatically search and connect to the most
recent Bluetooth
®
device that it was connected to. You will not
need to enter the PIN code again.
8. For best results, maintain a distance between the Bluetooth
®
device and Sing It Out Karaoke Microphone
TM
of approximately
10 feet or less; the Sing It Out Karaoke Microphone
TM
may
disconnect when the distance to the Bluetooth
®
device exceeds
10 feet.
AUTOMATIC SHUT-OFF
To preserve battery life, the Sing It Out Karaoke Microphone
TM
will automatically shut off after several minutes without any
button or voice input. The microphone can be turned on again by
pressing any button.
LOW BATTERIES
If the unit powers down or if the light fades out during play, please
install a new set of batteries.