EN - 14
Call waiting
1. When you hear a call waiting tone during a
call, press the FLASH key on the telephone
base to put your current call on hold and
take the new incoming call.
2. Press FLASH or the switch hook rapidly at
any time to switch back and forth between
calls.
Redial
The last dialed number is stored for 15 minutes.
To redial the last dialed number:
Lift the corded handset from the telephone
base, or press the LINE key or SPEAKER .
Listen for a dial tone. Then press REDIAL.
Mute
Mute the microphone
1. During a call, press the MUTE key:
The MUTE key illuminates when the mute
function is turned on. You can hear the party
on the other end but they cannot hear you.
2. Press the MUTE key again to resume the
conversation.
• The light on the MUTE key turns off.
Hold
To place a call on hold:
1. During a call, press the HOLD key to place
the call on hold. The LINE key flashes when
the call is placed on hold.
2. To release the call from hold, press the LINE
key.
Transfer a call
1. During a call, press the FLASH key to put the
current call on hold.
2. When you hear a dial tone, dial the number
you want to transfer the call to.
3. When you hear the ringing tone or the call
is answered, press the LINE key or place the
corded handset back on the telephone base
cradle. Then the call is transferred.
Computer port
You can route your computer through the
COMPUTER port (RJ-45) on the side of the
telephone base to get Internet access.
USB port
The port on the side of the telephone base
can be used for charging devices (up to 500mA
@ 5V). Charging will be suspended when there
is an incoming call or the telephone is in use.
To Next Page
Loading...
Need help?
General
