EN - 16
Question Suggestions
5. I cannot dial out.
• Try all the above suggestions.
• A prefix may be required for dialling some
internal or external calls
• Make sure there is a dial tone before dialling.
It is normal if the cordless handset takes
a second or two to synchronise with the
telephone base before producing a dial
tone. Wait an extra second before dialling.
• Check your server settings. If other telephones
in your hotel are having the same problem,
the problem is in the wiring or network server.
Contact your telephone service provider
(charges may apply).
6. The telephone cannot register to the
network server.
• Make sure your network is providing Power
over Ethernet (PoE).
• Make sure the initialization and system
registration process completes.
• If there is an error during the initialization and
system registration process, the SPEAKER
key flashes twice every second. Disconnect
the Cat-5 network cable from the network
wall jack and connect it back into the network
wall jack with Power over Ethernet (PoE) to
start the initialization and system registration
process again.
7. The telephone does not ring when there is
an incoming call.
• Make sure the Cat-5 network cable is plugged
into the LAN port of the telephone base
and the network wall jack with Power over
Ethernet (PoE).
• Check your server or telephone administrative
settings.
• If other telephones in your hotel are having the
same problem, the problem is in the wiring
or network server. Contact your telephone
service provider (charges may apply).
• Other electronic products such as HAM
radios and other DECT phones can cause
interference with your cordless phone. Try
installing your phone as far away as possible
from these types of electronic devices.
• The Cat-5 network cable may be defective.
Install a new Cat-5 network cable.
To Next Page
Loading...
Need help?
General
