92 93
9. Additional devices
Additional devices
Device setup
You can add VTech compatible Cordless audio doorbell and ULE Wearable home SOS
pendant (SN7021 and SN7022, both purchased separately) to your telephone system.
The Cordless audio doorbell (SN7021) helps you get notified at your telephone system upon
visitors’ arrival. When a visitor presses the Audio doorbell, both the base and the handset will
play the chime tone, and you can then answer the doorbell call and talk to the visitor at your
door with the handset or base. For operation instructions, refer to page 94 to page 105.
The ULE Wearable home SOS pendant (SN7022) function as same as the SOS button of your
cordless handset. It acts as a handy pendant to let you quickly call the preset SOS numbers for
help in an emergency, even when your telephone is beyond your reach. For detailed setups
and operations, refer to Set SOS emergency call section on page 13 to page 18, and
Make SOS emergency call section on page 38.
• You can add a maximum of two Cordless audio doorbells and 30 compatible ULE devices
to your telephone base.
Add and register a new device
1
When the telephone is
not in use, press and hold
PAGE on the telephone
base for about five
seconds until the visual
ringer indicator light turns
on. Release PAGE.
Press and hold CANCEL on the
back of the SOS pendant until
the LED light on the front flashes,
then release the button. When
registration is successful, the LED
light turns off, and then the base
beeps once.
SOS pendant
Press and hold the pair button on
the back of the audio doorbell
until the chime button LED light
flashes, then release the pair
button. When registration is
successful, the chime button LED
light becomes steady on, and
then the base beeps once.
Audio doorbell
2
• You need to register your newly purchased devices to the telephone base before use.
• Make sure the new devices are powered on with batteries or with AC power before
registering them to the telephone base.
To Next Page
Loading...
Need help?
General
