4
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of
the farm. Use a screwdriver to loosen
the screw.
3. Install 2 new AA (LR6/AM-3) batteries
following the diagram inside the battery
box. (The use of new alkaline batteries
is recommended for maximum
performance.)
4. Replace the battery cover and tighten the screw to secure.
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
Rotate the packaging locks 90 degrees
counterclockwise.
Pull out the packaging locks.
Unlock the packaging locks:
To Next Page
Loading...
Need help?
General