5
GETTING STARTED
Note:
This product is in Try-me mode in the packaging.
Plug the Microphone into any 6.35mm Mic Jack to exit Try-me mode.
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF.
2. Remove the battery cover on the back
of the unit.
3. If used batteries are present, remove
them by pulling up on one end of each
battery.
4. Install 6 new AA (LR6/AM-3) batteries following the diagram
inside the battery box. (The use of new alkaline batteries is
recommended for maximum performance).
5. Replace the battery cover.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the product.
• Dispose of batteries safely.
• Do not dispose of batteries in re.
To Next Page
Loading...