EasyManuals Logo

VTech Switch&Go DINOS User Manual

VTech Switch&Go DINOS
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
3
INCLUDED IN THIS PACKAGE
Switch & Go Dinos Thrash the T-Rex
3 Discs
Quick Start Guide
WARNING:
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy and should be discarded for your child’s safety.
NOTE:
Please save this Instruction Manual as it contains important information.
INSTRUCTIONS
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom of the unit. Use a
screwdriver to loosen the screw and then open the battery cover.
3. If used batteries are present, remove these batteries from the
unit by pulling up on one end of each battery.
4. Install 2 new AAA (LR03/AM-4) batteries
following the diagram inside the battery box.
(For best performance, alkaline batteries or
fully charged Ni-MH rechargeable batteries
are recommended).
5. Replace the battery cover and tighten the
screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.

Other manuals for VTech Switch&Go DINOS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the VTech Switch&Go DINOS and is the answer not in the manual?

VTech Switch&Go DINOS Specifications

General IconGeneral
MaterialPlastic
ManufacturerVTech
Power SourceBattery Powered
FeaturesTransforms from dinosaur to vehicle, sounds, lights
Educational AspectsImaginative Play
Battery TypeAA batteries
Product DimensionsVaries depending on the specific model
Item WeightVaries depending on the specific model
Age Range3-8 years

Related product manuals