4
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover on
the back of the unit, use a
screwdriver to loosen the screw
and then open the battery box.
3. Remove old batteries by pulling
up on one end of each battery.
4. Install 1 new AAA (LR03/AM-4) battery following the diagram
inside the battery box. (For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended).
5. Replace the battery cover and tighten the screw to secure.
Note: If there is no response when the scorpion is switched on,
please install brand new batteries and try switching the scorpion
on again.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach
of children.
To Next Page
Loading...
Need help?
General
