5
Getting Started
Before You Install
1 Choose a location for the Base near an electrical outlet and a
telephone jack.
This phone requires a modular telephone jack and a standard electrical
outlet (110v AC) not controlled by a wall switch.
2 Install the Handset battery.
Use only VTech battery.
Installation
a)Remove battery
compartment cover
by pressing on the
indentation and
sliding downward.
b)Align the two holes in the plug with the
socket pins, then snap the plug into
place.
c)Place the Battery Pack in the
compartment with the wires in the lower
right corner. Angle the top of the Battery
Pack under the top claws first, then snap
the bottom of the pack in. Place the
wires under the guide, located below
the Battery Pack.
d)Replace cover by sliding it up into place.
To Next Page
Loading...
Need help?
General
