VTech Toot-Toot Animals Farm - Battery Installation - Farm Play Set

7
BATTERY INSTALLATION – FARM PLAY SET
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back
of the electronic barn. Use a coin or a
screwdriver to loosen the screw.
3. Install 2 new AA (AM-3/LR6) batteries
following the diagram inside the battery
box. (The use of new alkaline batteries
is recommended for maximum
performance.)
4. Replace the battery cover and tighten
the screw to secure.
BATTERY NOTICE
• UsenewalkalinebatteriesorfullychargedNI-MH(NickelMetal-
hydride) rechargeable batteries for best performance.
• Useonlybatteriesofthesameorequivalenttypeasrecommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc) or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinre.
• Donotchargenon-rechargeablebatteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
Getting Started