VTech Toot-Toot Drivers 3-in-1 Raceway - Getting Started; Battery Installation; Battery Safety Notice

5
5
5
5
GETTING STARTED
Battery Removal And Installation
Race Car
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
bottom of the unit. Use a coin or a
screwdriver to loosen the screw.
3. Install 2 new AAA (AM-4/LR03)
batteries following the diagram
inside the battery box. (The
use of new alkaline batteries
is recommended for maximum
performance).
4. Replace the battery cover and tighten the screw to secure.
BATTERY NOTICE
• UsenewalkalinebatteriesorfullychargedNI-MH(NickelMetal-
hydride) rechargeable batteries for best performance.
• Useonlybatteriesofthesameorequivalenttypeas
recommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc) or rechargeable, or new and used batteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinfire.
• Donotchargenon-rechargeablebatteries.
• Removerechargeablebatteriesfromthetoybeforecharging(if
removable).
• Rechargeablebatteriesareonlytobechargedunderadult
supervision.