VTech Toot-Toot Drivers 4-in-1 Raceway. - INSTRUCTIONS; Battery Removal And Installation Stunt Car; Battery Information

5
INSTRUCTIONS
Battery Removal And Installation
Stunt Car
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom of the Stunt Car. Use a
screwdriver to loosen the screw and then open the battery cover.
3. If used batteries are present, remove from the unit by pulling up
on one end of each battery.
4. Install 2 new AAA (AM-4/LR03)
batteries following the diagram
inside the battery box. (For best
performance, alkaline batteries or
fully charged Ni-MH rechargeable
batteries are recommended).
5. Replace the battery cover and
tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
• Insertbatterieswiththecorrectpolarity(+and-).
• Donotmixoldandnewbatteries.
• Do not mix alkaline,standard(carbon-zinc) or rechargeable
batteries.
• Onlybatteriesofthesameorequivalenttypeasrecommendedare
to be used.
• Donotshort-circuitthesupplyterminals.
• Removebatteriesduringlongperiodsofnon-use.
• Removeexhaustedbatteriesfromthetoy.
• Disposeofbatteriessafely.Donotdisposeofbatteriesinfire.