10
ASSEMBLY INSTRUCTIONS
1. Assemble and attach the control tower components following the
steps below:
A. With the Control Tower Roof upside down, insert the Pillar
through the hole on the Control Tower Roof to the correct position
as shown and insert the Lock into the gap of the Control Tower
Roof to secure the Pillar to the Control Tower Roof, as shown
below.
B. Attach the Wall to the Control Tower Base and insert the
Control Tower Support, as shown below.
C. Attach the Control Tower Roof and Pillar part to the Control
Tower Base, Wall and Control Tower Support part, as shown
below. Make sure you hear a click sound to confirm the Pillar and
the Control Tower Base are firmly connected.
With the Toot-Toot Drivers
®
Airport, safety comes first. To ensure
your child’s safety, adult assembly is required.
To Next Page
Loading...
Need help?
General