VTech Toot-Toot Drivers Police Patrol Tower - GETTING STARTED; BATTERY INSTALLATION; BATTERY NOTICE

7
7
7
GETTING STARTED
BATTERY INSTALLATION
Police Car
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
bottom of the Police Car. Use a
coin or screwdriver to loosen the
screw.
3. Install two new AAA (AM-4/
LR03) batteries following the
diagram inside the battery box.
(The use of new alkaline batteries
is recommended for maximum
performance).
4. Replace the battery cover and
tighten the screw to secure.
BATTERY NOTICE
• Usenewalkalinebatteriesformaximumperformance.
• Useonlybatteriesofthesameorequivalenttypeasrecommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc)orrechargeable,ornewandusedbatteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinfire.
• Donotchargenon-rechargeablebatteries.
• Remove rechargeablebatteriesfromthetoybefore charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.