VTech Toot-Toot Drivers Smart Monster Truck - Getting Started; Battery Installation; Important Battery Information; Rechargeable Batteries

4
4
4
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of the
Smart Monster Truck. Use a screwdriver to
loosen the screw.
3. If used batteries are present, remove
these batteries from the unit by pulling
up on one end of each battery.
4. Install 4 new AA (LR6/AM-3)
batteries following the diagram inside
the battery box. (The use of new
alkaline batteries is recommended
for maximum performance).
5. Replace the battery cover and tighten the screw to secure.
IMPORTANT: BATTERY INFORMATION
• Insertbatterieswiththecorrectpolarity(+and-).
• Donotmixoldandnewbatteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Onlybatteriesofthesameorequivalenttypeasrecommended
are to be used. not use damaged batteries.
• Donotshort-circuitthesupplyterminals.
• Removebatteriesduringlongperiodsofnon-use
• Removeexhaustedbatteriesfromthetoy.
• Disposeofbatteriessafely.Donotdisposeofbatteriesinfire.
RECHARGEABLE BATTERIES:
• Removerechargeablebatteriesfromthetoybeforecharging.
• Rechargeable batteries are only tobe charged under adult
supervision.
• Donotchargenon-rechargeablebatteries.