EasyManua.ls Logo

VTech Tote & Go Laptop Pink - Software Installation; Troubleshooting

VTech Tote & Go Laptop Pink
14 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
SOFTWARE INSTALLATION
Before you can connect the VTech
®
Tote & Go Laptop
TM
to your computer,
you need to install the software on the VTech
®
Tote & Go Laptop
TM
website.
To begin the software installation, please go to the http://www.vtechkids.com/download
to download the setup file.
Once the setup process is complete, connect the VTech
®
Tote
& Go Laptop
TM
to the computer using a USB cable. Locate the
USB port on the left side of your product, and plug the device
into your computer’s USB port.
Note:
1. If the power supply is interrupted during the transfer of data to and from
the VTech
®
Tote & Go Laptop
TM
, the data on the VTech
®
Tote & Go Laptop
TM
may be lost. Before connection, please check and make sure that your
batteries are not running low on power.
2. Refrain from unplugging the USB cable during the transfer of data to and
from the VTech
®
Tote & Go Laptop
TM
. This may cause the data to
transfer abnormally or be lost.
If the VTech
®
Tote & Go Laptop
TM
is connected properly, you will see this
picture
shown on the screen of your VTech
®
Tote & Go Laptop
TM
.
Your progress will automatically upload to the computer. And you will be taken
directly to the VTech
®
Tote & Go Laptop
TM
website, where you can enjoy all of
the online features.
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat source.
3.
Remove the batteries when the unit is not in use for an extended period of time.
4. Do not drop the unit on a hard surface and do not expose the unit to
moisture or water.
TROUBLESHOOTING
If for some reason the program/activity stops working, please follow these
steps:
1. Turn the unit OFF.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit ON. The unit should now be ready to play again.
5.
If the product still does not work, replace with an entire set of new batteries.
SOFTWARE INSTALLATION / CARE & MAINTENANCE

Related product manuals