EasyManua.ls Logo

VWR International 3074 User Manual

Default Icon
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Operating Instructions
CO2 Incubator symphony 6.5 W
Question and Answer IconNeed help?

Do you have a question about the VWR International 3074 and is the answer not in the manual?

VWR International 3074 Specifications

General IconGeneral
BrandVWR International
Model3074
CategoryAccessories
LanguageEnglish

Summary

Installation and Start-Up

Unit Components

Details the parts of the incubator unit shown in Figure 1-1.

Control Panel

Explains the function of each button, indicator, and display on the control panel.

Control Panel Operation

Details the six operational modes of the incubator and their functions.

Unit Installation

Provides instructions for locating and setting up the incubator unit.

Stacking

Explains the procedure for stacking incubators using provided brackets.

Preliminary Cleaning

Instructions for removing protective coatings and cleaning interior surfaces.

Installing the Access Port Filter

Guides on locating and installing the access port filter.

Installing the Air Sample Filter

Steps for installing the air sample filter assembly.

Installing the Shelves

Instructions for installing the side ducts and shelf channels.

Leveling the Unit

How to check and adjust the unit's level using leveling legs.

Connecting the Unit to Electrical Power

Details on connecting the incubator to a grounded electrical circuit.

Filling the Water Jacket

Instructions for filling the incubator's water jacket.

Filling the Humidity Pan

Guidance on filling the humidity pan with appropriate water.

Connecting the CO2 Gas Supply

Instructions and warnings for connecting the CO2 gas supply.

Incubator Start-Up

Describes the final steps to start up the incubator after installation.

Setting the Operating Temperature Setpoint

How to set the desired operating temperature for the incubator.

Setting the Overtemp Setpoint

Instructions for setting the overtemperature safety limit.

Setting the CO2 Setpoint

Steps to set the desired CO2 concentration level.

Calibration

Calibrating the Temperature

Procedure for calibrating the temperature display against a reference.

Calibrating T/C CO2 System

Steps to calibrate the thermal conductivity CO2 sensor system.

Calibrating IR CO2 System

Procedure for calibrating the infrared CO2 sensor system.

Alarms

Alarms

Details the types of alarms, their descriptions, delay, and ring-back times.

Specifications

Specifications

Provides technical details for Temperature, CO2, RH, and fittings.

Specifications

Unit Heat Load

Details the heat output of the unit.

Shelves

Specifications related to the incubator shelves.

Construction

Details on the incubator's material and build.

Electrical

Electrical requirements and specifications.

Dimensions

Physical dimensions of the interior and exterior.

Weight (per unit)

Information on net, operational, and shipping weights.

Safety Specifications

Details on altitude, temperature, humidity, and mains fluctuations.

Installation Category and Pollution Degree

Explains installation categories and pollution degrees.

Related product manuals