To Next Page

To Previous Page

1 Introduction 6 Operation

Thank you for choosing the VXi D200 Dialpad.

RINGER SETTINGS

To adjust the volume of the ringer, set the RING switch

to the HI (H) or LOW (L) position. To turn the ringer o,

set the switch to the OFF (A) position.

FLASH SETTINGS

Set the switch to either A or B to enable the dialpad to

transfer calls.

MODE SETTINGS

If you have a touch tone phone, set the switch to “T”.

If you have a rotary phone, set the switch to “P”.

REC JACK (optional use)

This port can be used to connect a recording device for

call monitoring purposes. It is also possible to connect

a second headset with a 2.5mm plug, although it is

recommended to use a single headset.

EXT JACK (optional use)

The D200 Dialpad is a fully functioning telephone;

however, it is possible to connect the dialpad to a sec-

ond phone with an RJ-11 cord, if desired (not included).

Line CordD200 Dialpad

Headset Hook (Attach to side

of computer to hang the

headset when not in use.)

Included in the box:

Questions and Answers:

Need help?

Do you have a question about the VXI D200 and is the answer not in the manual?

VXI D200 Specifications

General