3 Installation 4 Operation
PLACE A CALL: Put the headset on and position the
microphone near the corner of your mouth about a
ngers-width away from your face. Press the ON/OFF
button. The In Use LED will light.
ADJUST SPEAKER VOLUME: Rotate the SPK-VOL
wheel until the volume level in your earpiece is
acceptable to you.
ADJUST MICROPHONE VOLUME: Rotate the
MIC-VOL wheel until your voice is heard clearly and
comfortably on the other end of the call.
Note: If you are hearing an echo of your own voice in the
earpiece, reduce the microphone volume.
ANSWER/END A CALL: When the phone rings, the
RINGER LED will ash. Press the ON/OFF button once to
answer and then again to end the call.
** IMPORTANT: Wait 10 seconds after connecting
the phone line before using (Whenever connect-
ing the phone line, or if the phone line goes out of
service, this 10 second wait time is required).
On the microphone there is a
painted dot or the word TALK
embossed on the plastic. This
mark MUST face your mouth.
Proper microphone position is
critical for good sound quality.
1. Plug the Line Cord into
the telephone wall jack and
into the D200 TEL jack. **
2. Attach a VXi headset to a VXi 1026
cord (both sold separately).
3. Plug the 1026 cord into the D200
HEADSET jack.
1026 Cord
VXi Headset
HEADSET Jack
TEL Jack
Telephone
Wall Jack
To Previous Page
Loading...
Need help?
General