5
• Do not wear metallic jewelry while installing or trouble shooting the Module.
• Do not change the wiring of bypass diodes.
CAUTION: In any case DO NOT STAND OR STEP on the modules, Do not drop or place
objects on the module(s) (such as tools), do not thump / give extra pressure on the
surface of the module(s) as localized high loads can induce severe
micro
-cracks at the
cell level, which in turn may compromise module reliability. Failure to comply with
above caution will void WAAREE’s warranty.
GUIDELINES & PRECAUTIONS FOR UNPACKING, HANDLING & STORAGE OF
PV MODULE
• The handling of Modules requires great diligence. Therefore, caution is required while unpacking,
transporting and temporarily storing these Modules.
• Unpack Module pallet with extreme care. Be careful while unpacking, transporting and storing the
Modules. Avoid Module mishandling during unloading.
• Do not stack more than the maximum amount of allowable pallets on top of each other.
• At the installation site, take care to keep Modules and particularly their electrical contacts clean.
• Do not carry the Module on Head.
• When carrying a bigger Module, two or more people should carry it by its frame and wear non-slip
gloves (to avoid injury by a slipping Module, cuts by the edge of a frame etc.). Do not leave the Module
unsupported or unsecured prior to installation.
• Store Modules in a dry and ventilated room.
• Do not place Modules on an uneven surface, for example, wind can cause a Module which is leaning
against a fence to fall and break.
• Avoid applications of excessive bending or twisting of the Module, it may cause severe micro-cracks at
the cell level, which in turn may compromise Module reliability.
• A Module with broken glass or torn backsheet cannot be repaired and must not be used since contact
with any Module surface or the frame can produce electrical shock.
To Next Page
Loading...