BA E16 en* 1.0 * E16_10_510.fm 5-59
Operation 5
De-pressurize the work hydraulics tier III
1. Stop the vehicle on firm, level, and horizontal ground.
2. Lower the attachment completely to the ground.
3. Lower the stabilizer blade to the ground.
4. Stop the engine.
5. Turn the starting key to position 1.
6. Move the control lever or the pedal of the hydraulic circuit in all
directions repeatedly.
➥ The pressure reduces. This can be seen by the brief movement the
hoses make as the pressure is released.
➥ Uncouple the attachment immediately after the pressure has been
released, otherwise pressure can be created again.
Pressure releases with proportional controls (option)
1. Park the machine on horizontal and level ground.
2. Lower the attachment completely to the ground.
3. Stop the engine.
4. Turn the starting key to position 1.
➥ Release the load only after you have engaged the starter and
waited 2 seconds (otherwise if actuated too early, the characteristic
curve is shifted and the load is not released).
5. Release the pressure on the auxiliary hydraulics or the 3rd control
circuit by pressing the rocker switch connected with the left or right-
side proportional joystick to the left and right.
➥ The pressure reduces. This can be seen by the brief movement the
hoses make as the pressure is released.
➥ Uncouple the attachment immediately after the pressure has been
released, otherwise pressure can be created again.
To Next Page
Loading...
Need help?
General
