BA E16 en* 1.0 * E16_10_700.fm 7-31
Maintenance 7
Empty the water separator (prefilter)
1. Preparations – see chapter “ Parking the machine” on page 5-12
2. Prepare a suitable container for collecting the fuel/water mixture.
3. Open the engine cover.
4. Turn ball-type cock A to the OFF mark.
➥ Fuel supply is interrupted.
5. Unscrew threaded ring B.
6. Collect the fuel/water mixture in the container.
Do not drain the red indicator ring C too.
7. Screw on the threaded ring B.
➥ The indicator ring is at the base of the water separator.
8. Turn ball-type cock A to the ON mark.
➥ Fuel supply is open.
9. Close the engine cover.
Empty the water separator (main filter)
1. Preparations – see chapter “ Parking the machine” on page 5-12
2. Prepare a suitable container for collecting the fuel/water mixture.
3. Open the engine cover.
4. Connect a drain hose to connection A. Place the hose into a container
on the ground.
5. Open screw B.
6. Collect the fuel/water mixture in a suitable container.
7. Close screw B.
8. Remove the hose.
9. Close and lock the engine cover.
Fig. 282 (symbolic representation)
B
A
To Next Page
Loading...
