MACHINE START-UP AND SHUTDOW
-
Operator correctly positioned inside the driver’s
cabin for use of the machine both in the transfer
phase and for working.
STARTING
- For proper starting follow the instructions described
above and as indicated below.
- Once the engine has started, gradually move the
accelerator (Ref. LA) lever to the idle position, at a
sufficiently low rpm and avoiding sudden acceleration,
until the hydraulic system has reached the operating
temperature (5 ÷10 min- utes depending on the
atmospheric conditions and climatic.
Start-up can only be carried out withthe safety
bar raised, Position “A”
Do not allow unauthorised persons to drive the machine. Remember that the responsibility for the
machine lies with the person who has received it.
Do not start using the machine until sure of its functioning. It is a good rule to practice in an
open and clear area when manoeuvres in which experience is lacking need to be carried out.
Concerning driving of the machine follow the instructions as described below, remembering which
is the front side of the machine.
STOPPING
To stop the engine it suffices to turn the key
(Fig.1 - ref. 2) anticlockwise.
It is advisable to idle the engine for a few
minutes before stopping the machine.
Remove the key whenever leaving the driver’s seat.
Never leave the machine running and unattended.
2
POSITIONA
POSITIONB
POSITIONB
Page 20 of 61
Item – Rev(s): 8009641121– 101
To Next Page
Loading...
