USE OF LIFTING FORKS
The forks must always and only be used with the self-levelling valve installed.
It is prohibited to exceed the indicated nominal capacity. Non-compliance of capacities
consented by the Manufacturer causes the loss of stability of the machine or even
overturning.
ONLY USE FORKS AUTHORISED BY THE MANUFACTURER
The maximum capacities corresponding to the centre of gravity of the load are stated below.
Position 1: Capacity Kg 325
Position 2: Capacity Kg 260
Position 3: Capacity Kg 210
Position 4: Capacity Kg 180
Position 5: Capacity Kg 125
Particular caution must be carried out when the forks are used to unload material with-
drawn in a high position and deposited in a low position.
Before proceeding with unloading, as well as checking the compatibility of the load with the
maximum load admitted, it is necessary to alternate, in tracts, descent with a backward
rotation of the forks (at least 4÷5 times) to maintain the load in a horizontal position or slightly
orientated towards the cabin.
Always block the forks to the fork-support plate and the latter to the machine’s quick fitting
in a way that the forks are always centred with the machine’s longitudinal axle.
The movement must be carried out with the load as low as possible; at very low speed and
on flat, compact ground. Lift the load. If necessary, only in the immediate vicinity of the place
of deposit.
Distance the forks adequately on the basis of the load to be lifted. The load must always be
positioned at the centre of the forks with the centre of gravity centred on themselves to
always have max. stability during movement. Never use the forks individually but in a couple
as supplied.
It is prohibited to lift and transport persons or live animals.
Do not pass or stop underneath a raised load. Never pass the load above people.
60 250 250
250
150
45
1180
Page 32 of 61
Item – Rev(s): 8009641121– 101
To Next Page
Loading...
