Wacker Neuson WM 650 User Manual

Maintenance WM 650 / WM 720
wc_tx000656gb.fm 25
5.4 Engine Oil and Filter
See graphic: wc_gr004396
Drain the oil while the engine is still warm. To drain oil:
5.4.1 Remove the filler cap (a) and drain cap (d). Drain oil into a suitable
container.
Note: In the interests of environmental protection, place plastic
sheeting and a container under the machine to collect the liquid which
drains off. Dispose of this liquid properly.
5.4.2 Re-insert the drain cap and tighten.
5.4.3 Fill the engine with the recommended oil to the upper limit mark on the
dipstick (b). See section Technical Data for the oil quantity and type.
Danger of burns! Care must be taken when draining hot engine oil. Hot
oil can burn!
To change the filter:
5.4.4 Drain the engine oil. Remove used filter.
5.4.5 Before installing the new filter, lightly oil the filter gasket (c) with fresh,
clean engine oil. Screw the filter on by hand until the gasket makes
contact, then tighten an additional 7/8 turn.
5.4.6 Fill the engine with the recommended oil. See section Technical Data
for oil quantity and type.
5.4.7 Start and run the engine to check for leaks. Stop the engine. Recheck
the oil level and add oil if required. Refer to the engine owner’s manual.
WARNING
wc_gr004396
a
b
c
d
d
WM 720
WM 650

Wacker Neuson WM 650 Specifications

General

Brand	Wacker Neuson
Model	WM 650
Category	Engine
Language	English