To Next PageTo Next Page
Need help?Do you have a question about the Waeco PerfectCharge W6 and is the answer not in the manual?
General| Brand | Waeco |
|---|---|
| Model | PerfectCharge W6 |
| Category | Battery Charger |
| Language | English |
Failure to observe safety warnings may result in injuries to persons or damage to materials.
Failure to observe cautionary warnings may result in damage to materials and impair product functioning.
The battery charger is allowed to be used only for purposes specified by the manufacturer.
The battery chargers are suitable for sealed starter batteries, lead-acid starter batteries and maintenance-free batteries.
To avoid damage to vehicle electronics, disconnect the vehicle battery from the on-board supply before charging.
Unscrew seal caps from battery cells and check the level of the battery fluid. Avoid contact with battery fluid.
Connect the red positive terminal to the battery positive pole and the black negative terminal to the battery negative pole.
Ensure the battery charger has a secure position and connect the plug into an earthed 230 V mains socket.
The MBC-600A has two LEDs: 'Power On' (green) and 'Full Auto Cut Off' (red) for battery status.
Models MBC-800A/1200A feature an amperemeter and 'Full'/'reverse' LEDs for charging status and polarity.
To avoid short-circuits, pull out the 230 V mains plug first after finishing the charging process.
Do not dispose of defective batteries in domestic waste. Return used batteries to the dealer or an authorised collection point.
