Waferlock C760 - Set Up The Programming Card; Link Card to Lock; Programming Card Usage; Lock Setup with App

2. Programming card is used to add/delete user
cards/badges, but not be used to unlock the cylinders.
3. Any MIFARE card will be able to unlock the cylinder
before it is programmed.
4. There is only ONE programming card per cylinder.
Please keep it safely.
5. You can use one programming card for multiple
cylinders.
Set Up The Programming Card Lock Setup with App
Insert the inner knob accurately until it reaches
the correct position based on your measured
thickness. Tighten the screw fully with the hexagon
key. (The inside knob of the C760 is adjustable.)
1. The WAFERKEY App works on iPhone with iOS
13.6 or later, or devices with Android 8.0 or later.
2. Be sure to accept any available firmware update.
3. Please refer to the instruction in WAFERKEY App
for more information.
4. Once the lock turns to App Mode, ALL the existing
user access settings (Key Card, Passcode ...)
will be deleted.
Note
1. Within these 10 seconds, do not remove the
programming card away from the reader.
Red
1
0
s
e
c
Programming
Open the App, simply use a Third Party Login
or register a WAFERKEY account.
Make sure the lock has been already
programmed by the programming card.
Turn on Bluetooth on your smartphone,
stay near the lock and follow the instruction
in the App.
2
3
Pair the lock in the App and start to use it.
4
1
0
s
e
c
Programming
Green X 3
Programming
1 “beep” sound
10 “beep” sound
Download the App by searching “WAFERKEY”
in the App Store (iOS) or on Google Play
(Android).
1
Follow below steps to get your lock setup with
WAFERKEY App. You can also use the mobile
App to set up your lock step-by-step and access
installation videos.
Questions about your new lock?
Let us help you!
support@waferlock.com
DON’T WANT TO USE THE APP?
Please go to Standalone Mode page for manual
programming instructions.
The Programming Card must be linked to the lock
before any other steps can take place.
Note
If 2 short beeps occur with the red light flashing 2
times, the setup was not successful. Please
re-program.
Tap the programming card on the reader, the
red light will start flashing for 10 seconds until
"1 long beep sound" followed by the green
light flashing 3 times.
Note
1