Wagan Solar e Power Cube 1500 Plus

Questions and Answers

A
ashley63Jul 26, 2025
Why is the run time less than expected on my Wagan Battery Charger?
- J
  Jessica SharpJul 26, 2025
  If the Wagan Battery Charger's run time is shorter than expected, it could be due to the Solar e Power Cube not being fully charged. To resolve this, charge it using the AC Charging Adapter. Alternatively, the product's power consumption might be higher than anticipated. In this case, check the power or “wattage” rating and compare it with the tables in the Battery Operating Times section of this manual.
H
harrisnicholasJul 31, 2025
How to fix television interference when using Wagan Solar e Power Cube 1500 Plus Battery Charger?
- D
  Dalton FranklinJul 31, 2025
  If you are experiencing television interference with your Wagan Battery Charger, specifically a picture breaking up (static), try placing the Solar e Power Cube as far away as possible from the TV, the antenna, and the coaxial cable.
B
Barbara HaleAug 3, 2025
What to do if the charging light is OFF when AC Charging Adapter is connected to Wagan Solar e Power Cube 1500 Plus?
- R
  roserebeccaAug 3, 2025
  If the charging light is OFF when the AC Charging Adapter is connected to your Wagan Battery Charger, ensure that there is AC power available at the wall socket.
J
Jennifer NealAug 8, 2025
How to eliminate static/noise interference in audio system when using Wagan Battery Charger?
- C
  Caleb CantrellAug 8, 2025
  If you're getting static/noise interference in your audio system when using the Wagan Battery Charger, it might be because your sound system has weak alternating current shielding. To address this, avoid using the Inverter with a low quality audio AC filtering system. Consider replacing your audio system with a high quality noise filtering system.
J
John MillsAug 12, 2025
Why is there no AC output and low voltage on my Wagan Solar e Power Cube 1500 Plus Battery Charger?
- S
  Steven BakerAug 12, 2025
  If your Wagan Battery Charger shows no AC output, the Green LED is not lit, and the voltmeter reads below 10 volts, it could be due to the battery voltage being too low. To resolve this, reduce the AC load and charge the Solar e Power Cube battery. Another potential cause is an excessive AC load.
L
laura35Aug 16, 2025
What to do if Wagan Battery Charger has no AC output and no displays lit?
- J
  Jeffrey DavisAug 17, 2025
  If your Wagan Battery Charger has no AC output and no displays are lit, it indicates that the Battery Disconnect Switch is OFF. Turn the switch ON to resolve this issue.
A
amy56Aug 20, 2025
Why do the 12 volt DC outlets switch on and off on my Wagan Solar e Power Cube 1500 Plus Battery Charger?
- C
  Christopher GeorgeAug 21, 2025
  If the 12 volt DC outlets on your Wagan Battery Charger switch on and off, it's likely that the DC Outlet is overloaded. Reduce the DC load to resolve this issue.