WAGNER EASYROLL - Important Note Regarding Product Liability

7
EasyRoll
EN
a
b
c
1) Unscrew the locking cap (a) on the valve housing
by turning counterclockwise.
2) Remove the retaining disk (b) and the duckbill valve
(c) from the valve housing
3) Clean these parts thoroughly using water.
4) Allow all parts to dry before reassembling.
5) Grease the tip of the rubber valve (c) with Vaseline.
6) Replace the duckbill valve (c) and retainer disk (b).
7) Screw the locking cap (a) on the valve housing by
turning it counterclockwise.
Parts List (Fig. 19)
Item Description Part No. Qty.
1,3,5 Roller core and cap 2422071 1
2 Roller cover 12 mm
Roller cover 20 mm (accessories)
0998230
0245717
1
1
4 Roller arm 2422073 1
6,7,8 Locking cap, retainer disk, duckbill valve 2325721 1
9 O-ring 2326966 2
10 Suction system 2423178 1
NOTICE: If after extended use you nd the plunger dicult to pull
while lling, apply a generous amount of petroleum jelly around
the o-rings located at the end of the plunger. We have included
a packet of petroleum jelly for you convenience.
Important Note regarding Product Liability!
Due to an EC ordinance in eect since 01.01.1990, the manufacturer is liable for his product
only if all parts originate from or were approved by the manufacturer and the devices
are assembled and operated correctly. The use of other accessories and spare parts can
partially or completely invalidate the liability.