6
Large volume container
GB
Bag support with pressing roller (not included in the
scope of delivery)
A) Assembly (Fig. 2)
Take o lid (1).1.
Mount bag support (2) at front on container (3).2.
Fold bag support over container.3.
Fix bag support with the two splints (4).4.
Risk of crushing! Bag support can fold for-
ward when the split pins are loosened, and
strike the oor.
Always hold the bag support rmly when
loosening the split pins.
2
3
4
1
B) Filling the reservoir
Place bag on support such that the face end is facing the 1.
opening.
Cut sack open.2.
Allow the coating material to ow into the receptacle.3.
Danger of crushing
Do not place hands under the roller.
Place pressing roller on rear end of bag and roll forwards 4.
several times over the bag.
Strip remaining coating material from sack opening with 5.
a spatula.
Agitator (not included in the scope of delivery)
Assembly
(Fig. 3)
If the bag support is not mounted, the
large volume container can tip up due to
the weight of the agitator.
Insert the container into the frame ro-
tated by 180° (B-coupling pointing for-
wards), in order to balance the weight of
the agitator.
Insert agitator with bracket (1) in handle and screw down (2).
2
1
Before use, always check that the agitator
is securely tted to the large volume
container.
Only operate agitator when lid is closed.
Always switch o agitator and disconnect
mains plug before reaching into container.
Start-up
An appropriate accessory is needed to con-
nect the large volume container.
You will nd the corresponding order num-
bers for your unit in the overview table.
Connect the accessory to the B coupling of the large volume
container and connect it with the suction system of your Wagner
unit.
The lower part of the suction pipe must be
removed for PC 430.
When coupling and decoupling the materi-
al hose, do not apply force to the ball cock.
Only use a suitable tool (recommended
Wagner coupling spanner, order no.
9100099).
Hold in place with a spanner on the con-
nector.
To Next Page
Loading...
