WAGNER W550 - Technical Data

GB
25
W 550
Problem Cause Remedy
Atomisation too
coarse
Viscosity of coating material too
•
high
Material volume too large
•
Material volume adjusting screw
turned too far to the right (+)
Nozzle contaminated
•
Air lter heavily soiled
•
Too little pressure build-up in
•
container
Thin ➞
Turn material volume ➞
adjusting screw to the
left (-)
Clean ➞
Change ➞
Tighten container ➞
Spray jet
pulsates
Coating material in container
•
running out
Air lter heavily soiled
•
Nozzle seal is missing or worn
•
Rell ➞
Change ➞
Insert an intact nozzle seal ➞
Coating
material causes
"paint tears"
Too much coating material
•
applied.
Turn material volume ➞
adjusting screw to the
left (-)
Too much fog of
coating material
(Overspray)
Distance to the object too large
•
Too much coating material
•
applied
Reduce distance ➞
Turn material volume ➞
adjusting screw to the
left (-)
Paint in the
ventilating hose
Diaphragm soiled
•
Diaphragm defective
•
Clean the diaphragm ➞
Replace the diaphragm ➞
18. Technical Data
Technical Data
Max. viscosity 90 DIN-s
Power source 230 V
~
, 50 Hz
Power consumption 280 W
Atomizing output: 65 W
Double insulation
Sound pressure level* 79 dB (A); Uncertainty K = 4 dB
Sound pressure output* 92 dB (A); Uncertainty K = 4 dB
Oscillation level** < 2.5 m/s²; Uncertainty K = 1.5 m/s
Weight 1,3 kg
* Measured in accordance with EN 50144-2-7:2000
** Measured in accordance with EN 60745-1