Wahl MAX 45 - Problem Elimination; Skin Injury; Appliance Is Not Working

9
•
Oil the blade set with the blade set oil (Fig. 10).
• We recommend that you clean and care for your blade set during and after clipping.
• Re-attachthebladesetaftercleaning(Fig.7/8).Switchtheapplianceonbriey(approx.10
seconds)toensuretheoillmisevenlydistributed.
• For a good and long-lasting cutting performance, it is important to oil the blade set frequently.
• If the cutting performance deteriorates after long use despite regular cleaning and oiling, the blade
set should be replaced.
Cleantheairlterregularlytoensurethesupplyofair:
1. Detachtheltercoverusingabluntleverandremovefromthehousing(Fig.11a)
2. Cleantheairlterusingthecleaningbrush.
3. Pushtheltercoverintothehousinguntilitlocksintoposition(Fig.11b).
4. Only wipe the appliance with a soft, slightly damp cloth. Do not use solvents or abrasives.
PROBLEM ELIMINATION
Bladesetiscuttingbadlyorpullinghairout.
Cause: Blade set is dirty, worn out or blade is blunt.
• Clean and oil the blade set (Fig. 9/10);
if this does not resolve the problem, replace the blade set (Fig. 6/7/8).
Skininjury
Cause: Too much pressure on the skin.
• Reduce pressure when cutting close to skin.
Cause: Damaged blade set.
• Check whether the blade edges, or teeth are damaged and replace the blade set if necessary.
• NEVERuseadamagedbladeasthiswillcauseinjury.
Appliance is not working
Cause: Defective power supply.
• Make sure that contact between the mains and the socket is faultless. Check the mains cable for
possible damage.
In the event that this information does not help you resolve your problem,
please contact our Customer Service team. Never attempt to repair the appliance yourself!