How to wear the TICKR
Snap the sensor into one side of strap.
Adjust the strap to fit your chest so when worn it will fit comfortably, but is not loose.
Moisten the contact point (the back of the device) on the strap with saliva or electrode gel to
improve conductivity.
Wrap the strap around your chest.
Snap the other end of the strap into place.
How to Pair your TICKR to the Wahoo Fitness app (iOS)
Download the Wahoo Fitness app from the App Store.
Open the Wahoo Fitness app. Make sure you have Bluetooth turned on.
Wake up your TICKR by wearing it on your chest. The TICKR wakes up when a heartbeat is
present.
Select “Sensors” in the bottom left corner.
Select “Add New Sensor”.
Choose your TICKR from the list of available sensors.
Once certain you are connected to the correct sensor, select “Save Sensor”.
Choose the workout profiles you would like your TICKR to be active for (ex. Running & Cycling).
Select “Done” to complete the pairing & workout selection process.
Select “Done” in the top left corner to exit the Sensors menu.
How to Pair your TICKR to the Wahoo Fitness app (Android)
Download the Wahoo Fitness app from the Google Play Store.
Open the Wahoo Fitness app. Make sure you have Bluetooth turned on.
Wake up your TICKR by wearing it on your chest. The TICKR wakes up when a heartbeat is
present.
Select “Saved Devices” in the top right corner.
Select the plus “+” icon to add a new sensor.
Choose your TICKR from the list of available sensors.
Once certain you are connected to the correct sensor, select “Save Device”.
Choose the workout profiles you would like your TICKR to be active for (ex. Running & Cycling).
Select “Ok” to complete the pairing & workout selection process.
Use the Back button to exit the menus and return to the Home Screen.
Your TICKR is now set up and ready for action. To use your TICKR, start a workout with one of the
profiles you paired it with. The Wahoo Fitness app will remember this pairing in the future. You
simply need to wake up your sensor and start a new workout to begin recording data!
NOTE: The TICKR Heart Rate Monitor uses a Blue and Red LED to give instant feedback to the
user during the pairing process. These LEDs operate for about 30 seconds to conserve battery.
The Red LED flashes each time a heartbeat is detected. The Blue LED represents your connection
state and has three modes:
To Next Page
Loading...
Need help?
General