Slow Blink (about once every second): TICKR is awake and not paired
3x Flash: Occurs the instant a connection is made.
Quick Blink (about twice every second): TICKR is paired to a device.
If a firmware update is available for your sensor, the Wahoo Fitness app will now prompt you to
proceed with performing an update. If you do not, the update may be performed later. Sensors
with updates available will appear in the menu of Saved Sensors marked with a badge to indicate
the update is available but not installed.
Workout Basics
Starting your Workout (iOS)
Make sure the device has Bluetooth turned on so it can communicate with your TICKR.
Select what kind of workout you wish to do from the list of workout types using the slider.
Select if you wish to have Audio Announcements turned on or off.
Wake up your TICKR by wearing it on your chest. The TICKR wakes up when a heartbeat is
present.
Make sure the TICKR is synced to your device. It will appear in the list of Linked Sensors for that
workout profile with an indication of signal strength shown on the far right when it is connected
to your device.
Select the green “Start” button to begin the workout. Information gathered from your TICKR will
now start to be displayed on your device.
Ending your workout (iOS)
To end your workout, simply select the red “Pause” button.
Select the red “Stop” button and either a) Discard Workout b) Save Workout or c) Return to
Workout.
If you elect to finish the workout, the Wahoo Fitness app will now display a summary of your
workout.
Starting your Workout (Android)
Make sure the device has Bluetooth turned on so it can communicate with your TICKR.
Select what kind of workout you wish to do from the list of workout types using the slider.
Use the Pencil icon to make changes to your workout if required. e.g. Select what you would like
the double tap function to perform on your TICKR Run or edit the Audio Announcements.
Select the green “Play” button to open a new workout.
Wake up your TICKR by wearing it on your chest. The TICKR wakes up when a heartbeat is
present.
Make sure the TICKR is synced to your device. It will appear in the list of Linked Sensors for that
workout profile with an indication of signal strength shown on the far right when it is connected
to your device (button located in the top right corner).
Select the green “Start” button to begin the workout. Information gathered from your TICKR will
now start to be displayed on your device.
To Next Page
Loading...
Need help?
General