Initial Settings
When the TV is turned on for the rst time, the menu
for the language selection appears on the screen. The
message “Welcome please select your language!”
is displayed in all language options sequentially in
the OSD.
By pressing the “
” or “ ” buttons highlight the language
you want to set and press OK button.
You can get information about the menu usage by
pressing INFO button. Press INFO button again to
exit the help menu.
After then, “First time installation” OSD will appear
on the screen. By pressing “
” or “ ” buttons, select
the country you want to set and press OK button.
Note: Country selection will not be available for UK.
Press OK to continue.
After then, the active antenna selection OSD appears
on the screen:
By pressing “
” or “ ” buttons, set active antenna
mode as on or off.
If an active antenna is connected to your TV, you can
select this option as On. Antenna power should be
“Off” when standard antenna is used instead of the
active antenna. See “Conguration Menu” in the
following sections for more information.
Press OK button on the remote control to continue
and the following message will be displayed on the
screen:
• To select the “Yes” or “No” option, highlight the item
by using “ ” or “ ” buttons and press OK button.
The IDTV will automatically tune to the transmission
channels, searching for digital terrestrial TV broadcasts
and displaying the names of channels found. This
process will take a few minutes. To cancel searching,
you can press M button at any time during the
process. The following OSD will be displayed during
the automatic search:
After Automatic Search is completed, the following
message will be displayed, asking for sorting option.
If you select “YES”, programme list will be sorted
according to LCN (logical channel number). Select
“NO” for using frequency sort. (This feature is
available for only Germany,Austria and Italy country
option)
After this operation, the following menu will appear
on the screen, asking for analog channel search:
To search for analogue channels, select “Yes”. TV
switches to the analogue TV mode. A menu will be
displayed to search for analogue channels.
Set Language item by pressing “
” or “ ” button.
Press “ ” or “ ” button to highlight Country item and
then use “ ” or “ ” to set. Press “ ” or “ ” button to
highlight TXT. Language. Set TXT Language by using
“ ” or “ ” button. To cancel, press the BLUE button.
When nished, press OK or RED button to continue
and the following OSD will be displayed:
After automatic tuning is nalized, a programme list
will appear on the screen. In the programme list you
will see the programme numbers and names assigned
to the programmes.
If you do not accept the locations and/or the names
of the programmes, you can change them in Program
table. For details, see the section, “Program table”.
To Next Page
Loading...
