Walker WP3214SMWI - Media Playback and Recording Management; Recording Configuration and Settings; Media Browser and Playback Modes

English - 10 -
Instant Recording
Press Record button to start recording an event
instantly while watching a programme. You can
press Record button on the remote control again to
record the next event on the EPG. In this case, an
OSD will be displayed, indicating the programmed
events for recording. Press Stop button to cancel
instant recording.
You can not switch broadcasts or view the Media
Browser during the recording mode. While recording
a programme or during the timeshifting, a warning
message appears on the screen if your USB device
speed is not sufcient.
Watching Recorded Programmes
Select the Recordings Library from the Media
Browser menu. Select a recorded item from the list (if
previously recorded). Press the OK button to view the
Play Options. Select an option then press OK button.
Note: Viewing main menu and menu items will not be
available during the playback.
Press the Stop button to stop a playback and return
to the Recordings Library.
Slow Forward
If you press Pause button while watching recorded
programmes, the slow forward feature will be
available. You can use Rapid advance button to
slow forward. Pressing Rapid advance button
consecutively will change slow forwarding speed.
RecordingConguration
Select the Recording Configuration item in the
Settings menu to congure the recording settings.
Format Disk: You can use the Format Disk feature
for formatting the connected USB disk. Your pin is
required to use the Format Disk feature (default pin
is 0000).
Default PIN code can change depending on the
selected country.
If you are asked to enter a PIN code for viewing a
menu option, use one of the following codes: 4725,
0000 or 1234.
IMPORTANT: Formatting your USB drive will erase
ALL the data on it and it’s le system will be converted
to FAT32. In most cases operation errors will be xed
after a format but you will lose ALL your data.
If “USB is too slow” message is displayed on the
screen while starting a recording, try restarting
the recording. If you still get the same error, it is
possible that your USB disk does not meet the speed
requirements. Try connecting another USB disk.
Media Browser Menu
You can play photo, music and movie les stored
on a USB disk by connecting it to your TV. Connect
a USB disk to one of the USB inputs located on the
side of the TV. Pressing the Menu button while in the
Media Browser mode will access the Picture, Sound
and Settings menu options. Pressing the Menu button
again will exit from this screen. You can set your Media
Browser preferences by using the Settings menu.
Loop/Shufe Mode Operation
Start playback with the Play
button and activate
TVplaysnextleandloop
the list.
Start playback with
OK and
activate
Thesamelewillbe
played in a loop (repeat).
Start playback with
OK/Play
button
and activate
Thelewillbeplayedina
shufe.
Custom Boot Up Logo
You can personalize your TV and see your favorite
image or photo on screen each time your TV boots
up. To do this, place your favorite image les in a USB
stick and open them from the media browser menu.
When you have chosen the desired image, highlight
it and click OK to view it in full screen. Click OK again
to choose the image as custom logo. If the image is
suitable* you will see it on the screen during the TV’s
next boot up.
Note: If you perform an FTI (rst time installation) the TV will
return to using the default logo.
*Images must have an aspect ratio between 4:3 to 16:9 and
they must be in .jpeg, .jpg or .jpe le formats.