English - 8 -
Installing the Batteries to the Remote
1. Lift the cover on the back of the remote upward
gently.
2. Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3. Replace the cover.
Connect Power & Antenna/Cable/Satellite
IMPORTANT: The TV set is designed to operate on 12
V DC. For this, an adaptor is used which gives 12 V
voltage. Connect this adaptor to a system that supplies
110-240V AC, 50/60Hz. After unpacking, allow the TV
set to reach the ambient room temperature before you
connect the set to the mains.
Switching On/Off
To Switch the TV On
Connect the power cord to the 110-240V AC,50/60Hz.
Then the standby LED lights up.
To switch on the TV from standby mode either:
Press the “
” button,P+/ P- or a numeric button on the
remote control.
Press the control switch located on the left side of the
TV. The TV will then switch on.
To Switch the TV Off
Press the “ ” button on the remote control or press
and hold the control switch on the TV until the TV
shuts down, so the TV will switch to standby mode
(Depends on the model).
To power down the TV completely, unplug the power
cord from the mains socket.
Note: When the TV is switched to standby mode, standby LED
can blink to indicate that features such as Standby Search,
Over Air Download or Timer is active. The LED can also blink
when you switch on the TV from standby mode.
First Time Installation
When turned on for the rst time, the “language
selection” menu appears. The message “Welcome
please select your language!” is displayed in all
language options listed alphabetically.
Press the “ ” or “ ” button to highlight the required
language, press OK button to select. “First Time
Installation” appears. Use “
” or “ ” button to set
the required country, and press “ ” button to select
Search Type. Use “
” or “ ” to set the desired
search type. Available search types are Digital and
analog, digital only and analog only. When set, press
“
” to select Teletext Language. Use “ ” or “
” button to set the “Teletext Language” and select
“Scan Encrypted” using “ ” or “ ” button. You
can set Scan Encrypted as Yes if you want to scan
coded stations.
Deafult PIN code can change depending on the
selected country.
To Next Page
Loading...