36
BXT Series
7.4 Grease Points
Use a hand-held grease gun for all greasing. Pump one shot
of grease per fitting.
• Wipe grease fitting with a clean cloth before greasing to
avoid injecting dirt and grit.
• If fittings do not take grease, remove and clean them
thoroughly. Replace grease fittings as necessary.
Location
Grease Points
– Every 50 hours of operation
or annually
1 Rotor Shaft Bearings
2 Wheel Bearings
3 Trailer Jack
4 Discharge Chute Rotation
01310
2
1
3
4
Fig. 28 – Grease Points (typical of all models)
To Next Page
Loading...
