Wanbo X5 Pro - Page 19

19
Signal Source Setting
To change the input source on your projector:
• Press the " " button located above the navigation pad on the remote control to enter the
input signal channel menu.
• Use the arrow keys to highlight your desired input source, and press "OK" to confirm and
switch to that source.
Additional Controls:
• To return to the previous menu layer, press the “←” (Back) button on your remote.
• To go back to the main interface, press the “ ” (Home) button.
Following these steps will allow you to easily manage media playback from USB drives and switch
between input sources on your projector.
Projection Distance Reference Guide
The following table provides a reference for optimal projection distances based on the desired screen
size. These distances assume no keystone correction and are based on the projector's default
projection ratio. Use this table to set up your projector at the appropriate distance to achieve the
screen size you need.
Projection Size
(inches)
Screen Dimensions (Length × Width,
m)
Distance from Lens to Screen
(m)
40
0.89 × 0.5
1.1
50
1.11 × 0.62
1.4
60
1.33 × 0.75
1.7
70
1.55 × 0.87
2.0
80
1.77 × 0.99
2.2
90
1.99 × 1.12
2.5
100
2.21 × 1.25
2.8
110
2.43 × 1.37
3.0
120
2.66 × 1.49
3.3
130
2.88 × 1.62
3.5
140
3.1 × 1.74
3.8
150
3.32 × 1.87
4.0
Note:
These projection sizes and distances are based on standard calculations and may vary slightly
depending on the actual setup and environment. Adjustments might be necessary to achieve precise
alignment.