Take flysheet and drape over
inner tent with door facing
correct direction.
Secure the flysheet and the
buckles on each corner using
the hook and loop tapes.
STEP 5
Attach the rear roof pole to rear
of roof by inserting the spigot
into the hole on the knuckle. It
is important to have the C clips
hooked on the pole before the
next step.
Adjust the tent to desired angle
and four leg poles stand evenly.
Important: Peg down all peg
points on the inner tent before
moving to the next step.
STEP 4
Use fibreglass pole to build the
front vestibule, push the pole
through the sleeve at the front
top of tent,insert pole ends into
the plastic tent feet, then attach
the fly to the pole by using C clips.
STEP 6
To Next Page
