Need help?Do you have a question about the W&H implantmed SI-915 and is the answer not in the manual?
General| Manufacturer | W&H |
|---|---|
| Model | implantmed SI-915 |
| Maximum power consumption | 180 W |
| Data logging | Yes |
| Control | Foot control |
| Application | Implantology |
| Power Supply | 100-240V AC, 50/60Hz |
Covers device usage, safety warnings, intended purpose, and user qualifications.
Outlines manufacturer's liability for safety, reliability, and performance based on adherence to instructions.
General safety advice including storage, checking for damage, and avoiding hazardous environments.
Specific warnings on fuse use, patient contact, using specific handpieces, and behavior during power/system failures.
Guidance on using the supplied mains cable, earthing, accessibility, and safe disconnection.
Warns about electromagnetic fields affecting active implantable medical devices (AIMD) and advises patient checks.
Instructions on coolant, irrigation tubing, and initial cleaning/disinfection procedures.
Step-by-step guide for connecting mains, foot control, motor, irrigant support, and irrigation tubing.
How to activate programs (P1-P5) and interpret display settings for speed and torque.
Procedure for increasing or decreasing motor speed using the PLUS/MINUS buttons within programs P1-P3.
Table of error codes (00-99) with descriptions and recommended solutions for the control unit.
General guidelines for hygiene, maintenance, protective clothing, and approved cleaning agents/disinfectants.
Recommends sterilization according to EN 13060, EN 285, or ANSI/AAMI ST55, with specific cycle details.
To Next Page
