W&T 58665 - Deactivating Box to Box Mode

136
W&T Box-to-Box mode
16�1�3 Deactivating Box to Box Mode
As with setting up the Box-to-Box connection, proper disab-
ling of this mode is also done using the Box-to-Box master.
Set the following parameters in the menu path SETUP Port
x r TCP/IP Mode r Box to Box to a value of 0 and save this
change:
... r Slave Port
Without the associated Box-to-Box-Master Box-to-Box-Slave
mode can only be quit using SETUP Port x r Port State r
Clear Port Mode.
The Connection State in the sub-menu SETUP Port x r Port
State must then be FREE.