Do you have a question about the W&T Com-Server++ and is the answer not in the manual?
Guide to configuring network parameters using the WuTility tool for IP assignment.
Explanation of dynamic IP assignment using the DHCP protocol for network connection.
Guide to configuring the Com-Server using a Telnet client application.
Steps to activate and use Web Based Management (WBM) for device configuration.
Procedure for saving configuration changes via Telnet or Browser interface.
Configuration options for the Com-Server operating system.
Configuration of serial port parameters like baud rate, data bits, stop bits, and parity.
Configuration of hardware, software, and special handshake modes for flow control.
Explains the Com-Server's role as a TCP server for serial data exchange.
Describes the Com-Server's independent connection opening to TCP servers.
Configuring TCP client mode with static server IP address and port.
Configuring TCP client mode using serial strings for server addressing.
Guide for downloading and installing the W&T COM Port Redirector software.
Procedure for setting up new virtual COM ports using the redirector configuration.
Configuration steps for Box-to-Box connections, including slave parameters.
Using the Com-Server as an FTP server for file transfer operations.
Automated file writing and reading to/from FTP servers.
Configuring the destination address and port for FTP server access.
Enabling the Com-Server to act as a Telnet server for character exchange.
Connecting to a Telnet server from the Com-Server via serial data reception.
Performing a forced reset of a Com-Server port via a dedicated TCP port.
Performing a complete software reset of the Com-Server device.
Reading and writing Com-Server configuration data over TCP ports.
Instructions on how to find and download the latest firmware from the manufacturer's website.
Procedure for updating firmware over the network using Windows and WuTility.
Using Easyterm or Hyperterminal for serial IP address assignment in Windows.