W&T Com-Server++ - Optional Settings

162
W&T Mode Telnet Client
20�1�2 Optional settings
Serial transmission parameters
SETUP Port x
UART Setup
...
Baud, Parity, Data Bits,
Stopbits, Handshake
Baud rate, data bits, parity and handshake procedure must
conform to the connected serial device. For details see section
Configuration of the Serial Port.
Special Options r Serial 0D->0D00
SETUP Port x
TCP/IP Mode
...
Telnet Client
...
Special Options
Serial 0D->0D00
If this switch is activated, an 00H is appended to the serially
received character 0DH: in other words, 0DH 00H is sent over
the network. This option may have to be activated for sending
binary files.