17
W&T Assigning the IP address
Subject to error and alteration
2�2 Assigning the IP using DHCP protocol
DHCP protocol is activated by the factory default settings,
so that in network environments dynamic IP assignment is
sufficient for connecting the Com-Server to the network. The
following parameters can be assigned using DHCP:
• IP address
• Subnet mask
• Gateway address
2�2�1 Manual activation of DHCP
To prevent unintended address assignments or address chan-
ges, DHCP protocol is automatically deactivated when using
all other methods for assigning the IP parameters. The follo-
wing methods are then available for later activation of DHCP.
• Management-Tool WuTility
Select the desired Com-Server from the device list and
click on the IP Address button. In the following dialog
check the option DHCP and then click on Next.
• Telnet-/WBM configuration
In the menu branch SETUP System r Setup TCP/IP r
DHCP Client you can activate DHCP protocol. For detailed
information, see the section Menu: SETUP System.
1
A set static IP address is deleted after DHCP is
activated and the associated automatic reset. The Com-
Server automatically sets this to 0.0.0.0 and starts sending
DHCP requests.
To Next Page
Loading...
