W&T Com-Server++ - Assigning IP Address

13
W&T
Subject to error and alteration
2 Assigning the IP address
The Com-Server is factory set to IP address 0.0.0.0. Before you can make
the entry in the Com-Server, you need to specify an IP address that is valid
for your network. Your system administrator will provide you with this. The
IP address must be unique within the network!
. ... using management tool WuTility
. ... using the ARP command
. ... using DHCP protokoll
. Assigning IP address, subnet mask and gateway address
through the serial port
. IP Address Conflict Detect